Electrician pulling new cable through open wall studs

Sioux Falls and nearby towns

Wiring and Rewiring Sioux Falls SD

Old circuits, added rooms, and rewires.

Wiring and rewiring in Sioux Falls covers old circuits, added rooms, and rewires of one area or a whole house. The plan says which cables stay and which are replaced. Attic and basement paths are checked before plaster is opened. Call (605) 250-4838.

Updated

What’s included

Rewiring is planned work. A single dead outlet is a repair unless the cable itself is bad.

  • New circuits for a kitchen, addition, or garage workshop. We list each new circuit before we pull cable.

  • Replacement of brittle or damaged cable found during a repair. We treat that cable as its own job.

  • Rewiring one room when the rest of the house can stay. We tell you what can stay on the old wiring.

  • Whole-house rewires when many circuits are past use. One bad device is a repair. A rewire is the bigger job.

  • Dedicated circuits for a heater, pump, or fixed appliance. The label on the appliance sets the breaker size.

  • Fishing cable where the finish can be saved, and open-wall runs during a remodel. We open plaster only where the wire has to go.

Signs you need it

Call us when the trouble is in the cable, not just the device. One dead outlet is still a repair unless the cable is bad.

  • Lights dim all over the house, not in one fixture. That is bigger than one lamp.

  • You find cloth-covered or cracked cable in an attic or basement. Leave it alone until we replace it.

  • Outlets have no ground and you need equipment that requires one. We add a ground only on a real path back to the panel.

  • A remodel opens walls and the old wiring is in the way. That is a good time for us to replace the cable you can see.

  • Breakers are the right size and still trip because the circuit is shared too widely. We can add a circuit and split that load.

What affects the price

What you pay depends on how hard the wires are to reach, the parts, and whether your city wants a permit. We do not list one price here. Typical published national ranges are shown below as a rough guide only.

  1. 1

    Opening finished walls, plaster, and brick costs more labor than wiring a house that is already down to studs. The length of each run and the number of new circuits change the materials.

  2. 2

    A one-room rewire is not priced like a whole house. Permit and inspection needs depend on the city.

24/7 emergency service

Exposed glowing or burning cable is an emergency, not a remodel. Shut the breaker off if you can do it safely and call.

Calls answered 24 hours a day, 7 days a week, including emergency service.

How much does it cost to rewire an old house?

Published national figures for a whole house rewire run about $2 to $4 per square foot, which is about $4,000 to $8,000 for a 2,000 square foot home. Older homes with plaster and lath walls, no open attic or basement, or knob and tube wiring land much higher, because more walls have to be opened and patched.

Typical published rewire ranges by home size
Home sizeTypical published rewire range (general)
Home size1,000 sq ftTypical published rewire range (general)$2,000 to $4,000
Home size1,500 sq ftTypical published rewire range (general)$3,000 to $6,000
Home size2,000 sq ftTypical published rewire range (general)$4,000 to $8,000
Home size2,500 sq ftTypical published rewire range (general)$5,000 to $10,000
Home size3,000 sq ftTypical published rewire range (general)$6,000 to $12,000

Typical published national ranges, not a quote. Rough estimate only. Your final price comes after an electrician sees the job.

Source: Angi, cost to rewire a house, updated Oct 13, 2026

Plaster and lath

Fishing new cable through plaster walls is slower than drywall, and openings have to be patched. See [Can new wire be fished without wrecking the plaster?](#faq-can-new-wire-be-fished-without-wrecking-the-plaster)

Staged rewires while you live there

A rewire can be done a few circuits or rooms at a time so most of the house keeps power each night. See [Do you rewire one room without doing the whole house?](#faq-do-you-rewire-one-room-without-doing-the-whole-house)

The panel often comes next

An old 60 or 100 amp service may not carry a modern home. See panel upgrade costs.

Knob and tube wiring removal cost

Knob and tube wiring was common in homes built from the 1880s to the 1940s. It has no ground wire and its insulation turns brittle with age. Published national figures put replacing it at about $12,000 to $36,600, with an average near $24,300, or about $10 to $20 per square foot, because the work is slower and more walls are opened.

Typical published knob and tube replacement ranges
Home sizeTypical published knob and tube replacement range
Home size1,000 sq ftTypical published knob and tube replacement range$10,000 to $20,000
Home size1,300 sq ftTypical published knob and tube replacement range$13,000 to $26,000
Home size1,600 sq ftTypical published knob and tube replacement range$16,000 to $32,000
Home size2,000 sq ftTypical published knob and tube replacement range$20,000 to $40,000

Typical published national ranges, not a quote. Rough estimate only. Your final price comes after an electrician sees the job.

Source: Angi, knob and tube wiring replacement cost, updated Oct 29, 2026

Partial or full removal

Electricians usually disconnect and abandon old knob and tube in the walls rather than pulling every piece out, which limits wall damage. Full removal costs more.

Insurance and home sales

Insurers and home inspectors often ask about knob and tube. A written scope of what was replaced helps with both.

Cloth wiring is different

See [Is cloth wiring the same as knob-and-tube, and does it need to be replaced?](#faq-is-cloth-wiring-the-same-as-knob-and-tube-and-does-it-need-to-be-replaced)

How the visit goes

Tell us what is wrong, and we stick to that. If we find a second problem, we tell you before we keep going.

  1. 1

    You call

    The walk-through marks which rooms stay on the old cable and which rooms get new cable. Attic and basement paths are checked before anyone talks about opening plaster. The notes list each new circuit, the path it takes, and the openings required.

  2. 2

    On site

    Walls open only where that list says so. New cable is pulled, devices are landed, and the panel directory is updated. Old cable that is left behind is made safe at both ends.

  3. 3

    The work

    Work held for a later phase is written as its own item.

Questions about this work

Do you rewire one room without doing the whole house?

Yes, when that circuit can be separated safely. The notes say what stays on the old wiring and what is new.

Can new wire be fished without wrecking the plaster?

Often in attics and basements. Lathe and plaster, brick, and insulated walls are slower. The visit tells you where an opening is required.

What if the house has aluminum wiring?

If aluminum branch wiring is found, those connections are their own scope.

Will a rewire include new devices?

The new cable ends at new devices where the old ones will not grip the new wire. A device swap by itself is outlet and switch work.

Is cloth wiring the same as knob-and-tube, and does it need to be replaced?

Cloth wiring is not the same as knob-and-tube. Cloth-covered cable uses fabric insulation around modern-style conductors; knob-and-tube runs individual wires on porcelain knobs and tubes. Both are aging systems. Cloth that is brittle, damaged, or overloaded should be evaluated and often replaced by a licensed electrician.

How much does it cost to rewire an old house in Sioux Falls?

Published national figures for a general rewire run about $2 to $4 per square foot, about $4,000 to $8,000 for 2,000 square feet. Older homes with plaster walls or knob and tube wiring often cost much more. We price your home after a walk through.

How much does it cost to remove knob and tube wiring?

Published national figures put knob and tube replacement at about $12,000 to $36,600, with an average near $24,300, or about $10 to $20 per square foot. Access through an attic or basement keeps it toward the low end.

Can I live in the house during a rewire?

Usually yes. Rewires can be staged so most circuits are back on each night. Expect some open walls and dust in the rooms being worked on.

Do I have to rewire the whole house at once?

No. Many owners start with the oldest circuits, the kitchen, or the bedrooms and finish the rest later. We tell you which circuits are the priority.

Electrician pulling new cable through open wall studs

Need help with wiring?

Calls answered 24 hours a day, 7 days a week, including emergency service. Tell us if it is your house or your business.

Call (605) 250-4838Email